Designing parts for SLA 3D printing
The key numbers for designing clear resin parts that print well: wall thickness, holes, clearances, drain holes and tolerances. Our engineers check every file before printing, so if something is close to a limit, we will tell you.
SLA design rules
| Feature | Recommended | Notes |
|---|---|---|
| Minimum wall thickness | 0.6 mm | Use 1 mm or more for unsupported or load-bearing walls. |
| Dimensional tolerance | ±0.2% (at least ±0.15 mm) | Tell us about critical dimensions when you order. |
| Minimum hole diameter | 0.8 mm | Small holes can close up with uncured resin. Drill for a precise fit. |
| Minimum pin or post diameter | 0.8 mm | Thin features can bend during post-curing. |
| Embossed and engraved detail | 0.5 mm high or deep | SLA holds fine text and detail well. |
| Clearance between mating parts | 0.2 mm | For parts that fit together after printing. |
| Drain holes for hollow parts | Two holes, 3 mm or larger | Lets uncured resin drain from inside. |
| Maximum part size | 450 x 450 x 400 mm | Larger parts can be split and bonded. |
General guidance for Somos® WaterShed clear resin on our SLA systems. Results depend on geometry, size and orientation. Somos® WaterShed clear resin material data.
Get better parts for less
Plan for supports
SLA parts need supports, which leave small marks where they touch. Tell us which faces are cosmetic and we will keep supports off them.
Hollow large parts
Hollowing a large part with drain holes saves resin and cost and reduces the risk of cracks.
Clear parts need finishing
For full transparency, clear parts are sanded and lacquered after printing. Ask for this finish when you order.
Send STEP when you can
We accept STL and STEP. STEP keeps exact geometry, which helps when holes or fits matter.
SLA design questions
What is the minimum wall thickness for SLA?
0.6 mm. For unsupported or load-bearing walls we recommend 1 mm or more.
How accurate are SLA parts?
Typically ±0.2%, with a lower limit of ±0.15 mm. Tell us which dimensions are critical.
Will you check my design?
Yes. Our engineers review every order before printing and will tell you if a wall, hole or gap is likely to cause a problem.
Ready to print?
Upload your STL or STEP file for an instant price. Our engineers check your design before printing.
